Airlift SmartAir Controls Series

Airlift SmartAir Controls Series

Air Lift SmartAir and Load Controller II Controls

Air Lift onboard controls manage air-spring pressure without requiring every adjustment at an external inflation valve. SmartAir automatic leveling and Load Controller II manual controls serve different needs, particularly when comparing front-to-rear leveling with independent side-to-side adjustment.

SmartAir responds to ride height

SmartAir uses an electronic sensing arrangement rather than a traditional mechanical contact arm between the frame and axle. Its purpose is to return the suspension toward a calibrated ride height as loading changes. The system includes compressor and control components, but installation still requires correct sensor positioning, wiring, plumbing, and calibration.

Single-path and dual-path operation

A single-path system adjusts the connected pair together for front-to-rear leveling. Dual-path control allows the two air springs to be adjusted independently, which matters when cargo is uneven from side to side. The listed systems control two air springs; a four-spring installation requires two compressor systems rather than assuming one controller handles everything.

Manual controls offer a different approach

Load Controller II lets the driver select pressure instead of automatically targeting a measured height. Part 25592 identifies the single-path arrangement, while 25812 identifies dual-path control. The low-pressure sensor activates the compressor when pressure falls below the system’s minimum threshold, helping protect compatible air springs from operation with insufficient pressure.

Observe the SmartAir exclusion

SmartAir II 25490 is the single-sensor arrangement, and 25491 is the dual-sensor arrangement. These SmartAir systems are not for Air Lift 1000-series products. Controller selection must match the air springs and intended plumbing. Leveling a loaded vehicle never authorizes exceeding its gross vehicle weight, axle, tire, payload, or towing limits.

Specifications and instructions

SKU On Board Air System Desired Operation
25592 Load Controller ll Single Front-to-Back Manual Control
25812 Load Controller ll Dual• Front-to-Back & Side-to-Side Manual Control
25490 SmartAir II Single * Front-to-Back Full Automatic Self-Leveling
25491 SmartAir II Duel *• Front-to-Back & Side-to-Side Full Automatic Self-Leveling
*Not for use withAir Lift 1000-•Controls 2 air springs; 4 air springs require 2 compressor systems

Applications and parts

Photos and diagrams

Related reading

Frequently asked questions

Which system handles uneven side-to-side loads?

A compatible dual-path system provides independent control of the two air springs.

Can SmartAir II be used with Air Lift 1000 bags?

No. The SmartAir II systems in this application exclude Air Lift 1000-series products.

Match the controller to your air springs

Contact Shockwarehouse

 

img

Added to cart successfully!